|
Ye' Old Workshop Build it or Break it, Never Fear! |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Picture Hanger Holder/Helper.
When it comes to hanging pictures, it can be a real PITA - but once properly located, really does a lot for the wall, room and the picture too.
So, I decided there has to be an easier way than locating it on the wall, having a second person say left/right/higher/lower, and then marking the location sort of haphazardly. I came up with this: **A 2 inch wide x 1 inch thick piece of scrap lumber that is approximately 36 inches long. ** drill or manually screw a 2 inch long Philips headed screw thru the lumber, and have it piercing approx. 1/4 inch thru. This leaves approx. 1/2 inch at the Philips headed end. **Place the picture equipped with wire onto the Philips end of the screw. Holding the piece of wood against the wall with the picture attached to the Philips end of the screw, have the 2d person tell you the location to go to -- i.e., left/right/up/down. Balance the picture and be careful to not make extreme quick moves. Go slow. **Once the location is determined, have the 2d person remove the picture from the wooden picture holder/helper. **With the picture removed, and the picture helper/holder still against the wall, tap the end with the Philips screw into the wall with your hand. This will leave a mark for the picture hanger. **Mount the picture hanger on that mark, hang the picture, adjusting for levelness. Done. Perfect. Best Sirs, Bob **
__________________
Amps:VAC 450iQ Monos in Silver Flake on HRS M3X2-1921's, HRS G7 Footers/G-Links & Sound Anchor Conecoasters. Preamp:VAC Statement (on order) (Silver Flake) Digital Source: dCS Rossini CD/SACD Transport, Vivaldi APEX DAC, Upsampler Plus & matching Clock (Silver) Analogue Preamp:VAC Renaissance SE Phono stage in Silver Flake with XLR Output Option & with Nordost Valhalla XLR's. Analogue Sources:SME 20/2 w/SME V arm & Nordost Odin 2 Tone Arm Cable, Palo Santos Presentation Cartridge & Akai GX-400D Reel-to-Reel w/relapped heads by JRF Magnetic Sciences. Akai RC-17 cabled remote (original owner since 1974). Vibration Control:TT on HRS M3X2-1921 shelf. Speakers:Wilson Audio Alexia V (on order in Ferrari Argento Silver/Parchment grills sitting on Acoustic Diode Kit). Power Cables:4 Nordost Odin Supreme Reference on amps, preamp & DAC. Ansuz Acoustics C2 on Transport & Clock. Power Distribution:Ansuz Mainz D3 Distributor & Ansuz Mainz C2 1M Power Cable Power Outlets:Furutech GTX-D NCF (R) duplex outlet, GTX Wall Plate & Duplex Cover (x2) on dedicated, same panel phase, 20A breakers. Speaker Cables:2M Nordost Odin 2 Supreme Reference on Nordost Sort Lifts. Signal Cables:Nordost Odin XLR's on dCS DAC & Amps. Digital Cables: Nordost Odin 2's, 110-ohm AES/EBU on dCS Transport to DAC. Clock Cables:5 each 75 ohm 1.25M Nordost Valhalla BNC/BNC Digital Ethernet Cable: WireWorld Platinum 1M Starlight® 8 Twinax Headphones:Vintage Koss Pro IV AA. RCM: Audio Desk PRO Tube Test Gear:Mint late '60's/calibrated Heathkit TT-1A, MaxiMatcher Power Amp & Preamp & Space Tech Labs ATT-3.02 tube test sets. Last edited by vintage_tube; 07-03-2017 at 04:55 PM. |
#2
|
||||
|
||||
Bob
Great idea! Thank you
__________________
“Life is what happens to you while you’re busy making other plans” |
#3
|
||||
|
||||
You're welcomed. That's what you do when you don't work -- dream up crap that does work.
Best Sir, Bob
__________________
Amps:VAC 450iQ Monos in Silver Flake on HRS M3X2-1921's, HRS G7 Footers/G-Links & Sound Anchor Conecoasters. Preamp:VAC Statement (on order) (Silver Flake) Digital Source: dCS Rossini CD/SACD Transport, Vivaldi APEX DAC, Upsampler Plus & matching Clock (Silver) Analogue Preamp:VAC Renaissance SE Phono stage in Silver Flake with XLR Output Option & with Nordost Valhalla XLR's. Analogue Sources:SME 20/2 w/SME V arm & Nordost Odin 2 Tone Arm Cable, Palo Santos Presentation Cartridge & Akai GX-400D Reel-to-Reel w/relapped heads by JRF Magnetic Sciences. Akai RC-17 cabled remote (original owner since 1974). Vibration Control:TT on HRS M3X2-1921 shelf. Speakers:Wilson Audio Alexia V (on order in Ferrari Argento Silver/Parchment grills sitting on Acoustic Diode Kit). Power Cables:4 Nordost Odin Supreme Reference on amps, preamp & DAC. Ansuz Acoustics C2 on Transport & Clock. Power Distribution:Ansuz Mainz D3 Distributor & Ansuz Mainz C2 1M Power Cable Power Outlets:Furutech GTX-D NCF (R) duplex outlet, GTX Wall Plate & Duplex Cover (x2) on dedicated, same panel phase, 20A breakers. Speaker Cables:2M Nordost Odin 2 Supreme Reference on Nordost Sort Lifts. Signal Cables:Nordost Odin XLR's on dCS DAC & Amps. Digital Cables: Nordost Odin 2's, 110-ohm AES/EBU on dCS Transport to DAC. Clock Cables:5 each 75 ohm 1.25M Nordost Valhalla BNC/BNC Digital Ethernet Cable: WireWorld Platinum 1M Starlight® 8 Twinax Headphones:Vintage Koss Pro IV AA. RCM: Audio Desk PRO Tube Test Gear:Mint late '60's/calibrated Heathkit TT-1A, MaxiMatcher Power Amp & Preamp & Space Tech Labs ATT-3.02 tube test sets. |
#4
|
||||
|
||||
Bob, I like that idea also.
__________________
Paul Harbeth 40.3 XD, Sound Anchor stands w/ Stillpoints, Luxman M900 & C900, Aurender N20, Jay's Audio CDT3 - MK3 CD player, Mola Mola Tambaqui DAC, Shunyata Everest, Altaira |
#5
|
|||
|
|||
Its so simple..its brilliant!...
Any thoughts of getting a patent.. (you know that's how George Foreman got famous) |
|
|
Audio Aficionado Sponsors | |