#1
|
|||
|
|||
ARC VSi75
I just received the ARC VSi75 Owners manual
if anybody wants to check it out just let me know and I will send a copy to your email Nelson |
#2
|
||||
|
||||
Nelson...I was not aware there was a VSi75? Is this an integrated based on the Ref 75 design?
|
#3
|
|||
|
|||
Wow!
That sounds very interesting...... |
#4
|
|||
|
|||
I've been told it's a totally new package and not an upgrade from the VSi60. Can ya post the specs?
|
#5
|
|||
|
|||
Specifications
Power Output: 75 watts per channel continuous from 20Hz to 20kHz. 1 kHz total harmonic distortion typically 1.5% at 75 watts, .05% at 1 watt. Approximate actual power available at “clipping” 80 watts (1kHz). (Note that actual power output is dependent upon both line voltage and “condition” i.e.: if power line has high distortion, maximum power will be affected adversely, although from a listening standpoint this is not very critical.) Power Bandwidth: (-3dB points) 12Hz to 70kHz. Frequency Response: (-3dB points at 1 watt) 1.0Hz to 70 kHz. Input Sensitivity: 0.55V RMS Single-ended for rated output. (32.5dB gain into 8 ohms.) Input Impedance: 52.5K ohms Single-ended. Inputs (5): 1, 2, 3, 4, 5 (Single Ended RCA connectors). Maximum Input: 10V RMS (any input). Output Polarity: Non-Inverting (any input). Push Buttons: Volume up, Volume down (103 steps), Power, Input, Mute, Bias. All functions on IR remote control. Output Taps: 8 ohms, 4 ohms. Output Regulation: Approximately 2dB 8 ohm load to open circuit (Damping factor approximately 4). Overall Negative Feedback: 4dB. Slew Rate: 10 volts/microsecond. Rise Time: 4 microseconds. Hum & Noise: Less than 1.0 mV RMS -88dB below rated output (IHF weighted, Vol down). Power Supplies: Electronically regulated Low and High voltage supplies for input stages. Automatic 40 sec. warm-up/brown- out mute. Power Supply Energy Storage: Approximately 350 joules. Power Requirements: 100-125VAC 60Hz (200-250VAC 50Hz) 400 watts at rated output, 600 watts maximum, 210 watts at “idle’: 1.0 watt power off. Tubes Required: 2-Matched pair KT120-Power Output; 2 -6H30 driver. Dimensions: Width 14.5” (36.8 cm) Height 9.25” (23.5 cm) Depth 16.25” (41.3 cm) Rear connectors extend .88” beyond chassis. Weight: 36.4 lbs. (16.5 kg) Net; 49.3 lbs. (22.4 kg) Shipping. This unit is RoHS compliant HIGH DEFINITION® Specifications subject to change without notice. ©2013 Audio Research Corporation.  |
#6
|
|||
|
|||
|
#7
|
|||
|
|||
Quote:
always with the latest in arc |
#8
|
|||
|
|||
Look they are going with the Digital Front Display
very nice !! |
#9
|
|||
|
|||
Tube meter
I like it !!!! |
#10
|
|||
|
|||
Very nice!!! Thanks for sharing.
|
|
|
Audio Aficionado Sponsors | |