|
VPI Industries Turntables Made in USA |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Help removing plinth from VPI HW-19 JR
Are there any owners out there of the VPI HW-19 Jr that could provide me with direction on how I go about moving the plinth. I would like to have a local cabinet maker build a new one for me in cherry to match my Aerial 7T's.
__________________
[list] Analog: VPI Prime Signature Turntable in Rosewood, Ortofon Cadenza Bronze, Digital: Aurender N10, Holoaudio KTE May, Oppo 203, Preamplifier: Luxman C-10X, Parasound JC3 Jr, Amplifier: Luxman M-10X, Speakers: Bowers & Wilkins 801 D4, Power Management: Audioquest Niagara 5000, Cables: Nordost Tyr 2, Wireworld Eclipse 7 & 8, , Rack: Core Audio Designs plyKraft 3L (x2) |
#2
|
|||
|
|||
Remove the platter. Then either get something between the plinth and the outside frame and lift, or get a start by using the mounting screws/pillars for the vpi pulley cover.
If it is the original Jr. plinth it is not particularly heavy. |
#3
|
||||
|
||||
You could also get underneath the table and push up on the plinth. The Juniors used sorbothane pucks so I bet after this long they are stuck pretty well to both the plinth and the wood surround. You will need to use some force to get it them to separate.
|
#4
|
||||
|
||||
Thank you for the advice.
__________________
[list] Analog: VPI Prime Signature Turntable in Rosewood, Ortofon Cadenza Bronze, Digital: Aurender N10, Holoaudio KTE May, Oppo 203, Preamplifier: Luxman C-10X, Parasound JC3 Jr, Amplifier: Luxman M-10X, Speakers: Bowers & Wilkins 801 D4, Power Management: Audioquest Niagara 5000, Cables: Nordost Tyr 2, Wireworld Eclipse 7 & 8, , Rack: Core Audio Designs plyKraft 3L (x2) |
|
|
Audio Aficionado Sponsors | |