Furman

[Rayooo]

..truth be told the original Furman was in fact a bit overly sensitive to OV. Although I doubt I'd have actually had it changed to be less so.

'would rather it be a tad over sensitive than possible a bit under-sensitive.

[prepress]

I see this morning the line is running 124-125V currently. Not a problem unless I need air conditioning.

Furman suggests troubleshooting further, starting with putting the SPR directly into the wall. I'm reluctant to do that because it's a reconfiguration hassle or will cost me to buy an adequate extension cord or 15A to 20A adapter. OR...run the SPR's power cord across the floor straight to the wall plug and connect via my Venom extension cord; no extra expense and a minor hassle only. Maybe I'll try that. Currently, the Elite is going to the wall via a Wireworld Stratus snaking behind my LP cabinets and connected to the wall via the Venom.

I've also noted that even though it's the same duplex, voltage between the two plugs varies. On the Tripplite setup, the Smart 1500LCD reads 124 and the HT1210 (which the 1500 is plugged into) reads 123 currently; the SPR reads 124 (the Elite has no readout). Sometimes the three units agree, sometimes not. At this exact moment of typing they all read 124, but that won't last. And it didn't.