Burmester 035

[m.tonetti]

Originally Posted by joeinid

Hi Bob,

All you need to do is either connect everything normally and hit the phase switch on the preamp (which is what I do on my 077). OR, reverse the speaker leads at the speakers and all is good again.

No issues or problems at all.

From the user manual of 077:
NOTICE: Please be advised that each input can be reversed separately. A phase reversal of the outputs is not intended.

[joeinid]

Originally Posted by m.tonetti

From the user manual of 077:
NOTICE: Please be advised that each input can be reversed separately. A phase reversal of the outputs is not intended.

I'll have to re-read that in the manual. So do you think I should reverse the speaker terminals and leave the phase switch alone? I've tried it both ways and seem to prefer it hooked up normally and use the phase switch on those inputs that need it. What do you think Massimo?

[m.tonetti]

Originally Posted by joeinid

I'll have to re-read that in the manual. So do you think I should reverse the speaker terminals and leave the phase switch alone? I've tried it both ways and seem to prefer it hooked up normally and use the phase switch on those inputs that need it. What do you think Massimo?

If the source isn't Burmester then you have to invert the input signal in the pre-077, otherwise you must use a XLR custom cable with 2 -> 3 and 3 -> 2. Alternatively you reverse the speaker cable terminals.

In the case of 035 there is no way to reverse the input phase.