|
Audio Research State of the Art Audio Reproduction |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Is the ARC Ref 75 enough for TAD CR-1's ....
If I don't crank my music? Could I get away with it? My Dart is 160 wpc @ 4 ohms and it is sufficient. Thoughts ?
SPECIFICATIONS POWER OUTPUT: 75 watts per channel continuous from20Hz to 20kHz. 1kHz total harmonic distortion typically 0.6% at 75 watts, below 0.05% at 1 watt. Approximate actual power available at ‘clipping’ 76 watts (1kHz). (Note that actual power output is dependent upon both line voltage and ‘condition’ i. e.: if power line has high distortion, maximum power will be affected adversely, although from a listening standpoint this is not very critical.) POWER BANDWIDTH: (-3dB points) 7Hz to 60kHz. FREQUENCY RESPONSE: (-3dB points at 1 watt) 0.7Hz to 75 kHz. INPUT SENSITIVITY: 1.4V RMS BAL for rated output. (25 dB Bal gain into 8 ohms.) INPUT IMPEDANCE: 300K ohms Balanced. OUTPUT POLARITY: Non-inverting. Balanced input pin 2+ (IEC-268). OUTPUT TAPS: 8 ohms, 4 ohms. OUTPUT REGULATION: Approximately 1.0dB 8 ohm load to open circuit (Damping factor approximately 8). OVERALL NEGATIVE FEEDBACK: 15dB. SLEW RATE: 10 volts/microsecond. RISE TIME: 4.0 microseconds. HUM & NOISE: Less than 0.06mV RMS – 112dB below rated output (IHF weighted, input shorted). POWER SUPPLY ENERGY STORAGE: Approximately 520 joules. POWER REQUIREMENTS: 105-125VAC 60Hz (210- 250VAC 50Hz) 410 watts at rated output, 500 watts maximum, 230 watts idle. TUBES REQUIRED: 2 – Matched pair KT120 – Power Output; 2 – 6H30 Driver. DIMENSIONS: 19" (48.3 cm) W x 8.75" (22.2 cm) H x 19.5" (49.5 cm) D. Handles extend 1.5" (3.8 cm) forward. WEIGHT: 47 lbs. (21.3 kg) Net; 63 lbs. (28.6 kg) Shipping. |
|
|
Audio Aficionado Sponsors | |