Krell Showcase-Possible to remove front?

[Mark Manner]

I have a Krell Showcase pre/pro in my system, and the red screen covering the display has some spots/deterioration on the back side. This partially obscures the display. It isn't worth sending the box back to Krell, but if I could remove the front plate to get at the back of that red screen and clean it, I would. Anyone know if this is possible? It appears the front is attached at the 4 corners with torx screws. I attach a picture below so show the problem. Not a great picture, but you can see the spots to some extent that are on the back surface of the red screen that covers the display.
Thanks,
Mark

[Mark Manner]

Here is a pic that shows the spots better. It makes it look worse in some ways than it is.

[Elberoth]

Take the top cover off. You will probably need to disconnect the cables going to the front panel first, before you attempt to remove the front panel. Then remove the two torx screws that hold the front panel from the bottom. After that, you can remove the remaining 4 torx screws on the sides.

Krell Showcase stuff is build like LEGO. Very easy to assemble / disassemble. All you need is a set of torx screwdrivers, as there are two different sizes used.

[Mark Manner]

Originally Posted by Elberoth

Take the top cover off. You will probably need to disconnect the cables going to the front panel first, before you attempt to remove the front panel. Then remove the two torx screws that hold the front panel from the bottom. After that, you can remove the remaining 4 torx screws on the sides.

Krell Showcase stuff is build like LEGO. Very easy to assemble / disassemble. All you need is a set of torx screws, as there are two different sizes used.

Thanks much!

[Elberoth]

Ofc, 'All you need is a set of torx screwdrivers' not screws.

Already corrected the mistake.