#1
|
||||
|
||||
Pass blue meter light = LED?
In the newer .8 series, are the blue meter lights LED or traditional bulb? Curious.... Thx
__________________
McIntosh Labs |
#2
|
|||
|
|||
i dont know but i love Class A
|
#3
|
||||
|
||||
For the .5 series I'm pretty sure the blue lights are LEDs.
|
#4
|
|||
|
|||
If its blue its an LED, seems to be a mantra for audio equipment
There was a time when LED's were considered bad for analogue circuits, what changed? BTW where are the bi and tri coloured LED's nowadays? |
#5
|
|||
|
|||
All leds all the time..... all the way back to ALEPH proto's in 1989.
Cyclotronguy |
#6
|
|||
|
|||
from Absolute sound:
`...With the success of the INT-150 under its belt, Pass Labs has taken the next logical step by releasing not one but two new integrated offerings, the INT-60 and INT-250. Both are Class AB designs with heavy Class A bias based on Pass Labs' latest Point 8 Series of amplifiers. The INT-250—the subject of this review—weighs in at 105 pounds and outputs 250Wpc into 8 ohms and a stump-pulling 500Wpc into 4 ohms. It was optimized for greater flexibility with grunt-worthy speaker loads of 86dB sensitivity or less. The INT-250 features high-voltage rails and output stages, along with the iconic glowing meter found on Pass Labs’ Point 8 amplifiers, direct-access buttons for the four inputs on the faceplate, and a blue LED output-level display. The volume control knob, which is about the size of a hockey puck, is solid aluminum and beautifully weighted—it’s an old-school joy to use... ` |
#7
|
||||
|
||||
Can confirm it´s leds. I have replaced all on my XA60.5 monoblocks.
A bit nerv racking but it was a pretty easy operation. One of the Monoblocks small leds, that always is on, was bad and I decided to replace all when I was at it. |
Thread Tools | |
Display Modes | |
|
|
Audio Aficionado Sponsors | |