#141
|
|||
|
|||
Quote:
My buddy and I in St. Louis (see Steve's Vs virtual system on Agon and WBF) did the work to have HDPlex 300W and Uptone prototypes built that could handle Wavelet power spec and cabling about 5 years ago so I am no stranger to what an external power supply can do for Wavelet with a good umbilical! While I don't stream digital into the DAC on Wavelet or use it as a preamp as I have transport, DAC and preamp feeding Wavelet, I do wind up using the internal DAC after the results of room correction must be converted back to analog to be output to amps and speakers. It's a fine apodizing DAC and has great sonics! Last edited by SCAudiophile; 01-28-2021 at 03:53 PM. |
#142
|
|||
|
|||
Quote:
|
#143
|
|||
|
|||
Quote:
analog in => convert to digital 56-bit Room Correction in digital domain D=>A step after room correction back to analog outputs to speakers/amps... |
#144
|
||||
|
||||
I had a dac and a nice pre amp and I thought the system sounded better even though it added an a/d conversation to the chain. After I added the linear power, I think the music sounds better going directly to the dac in the wavelet. If you haven’t tried this give it a try. Now I’ve been using my preamp only when I use headphones and my turntable.
__________________
PS Audio P10, dCS Bartok, McIntosh C1100, Legacy Wavelet, McIntosh 452, Legacy Aeris |
#145
|
|||
|
|||
Quote:
Wavelet benefits from best input quality being fed in... I also spin discs exclusively for best quality source mmaterial and so do not stream or have a server. |
#146
|
|||
|
|||
Quote:
|
#147
|
|||
|
|||
Quote:
I'm sure that since you'd literally be walking in decided based upon forum feedback and great reviews out there that a dealer could help you out achieving your goal with very little time spent... |
#148
|
|||
|
|||
Quote:
|
#149
|
|||
|
|||
Quote:
Can you give some advise on the ethernet cables? I am looking at upgrading the Ethernet cables in my system and needsome help. From the wall to my modem>router, then I run a 50 foot cat6 to my the theater room up stairs to a Ethernet splitter. From the splitter I run a cat6 patch cable to my AppleTV, a patch cable to my Roon Nucleus+ and a patch cable to my MX170 theater processor. I was thinking of putting a Ethernet cable between the router and modem down stairs, and what would you suggest from the splitter to the Apple TV, Roon, and Mx170? Any Help on this would be greatly appreciated |
#150
|
|||
|
|||
Well,..you asked [emoji2]. The beauty of it is, even with Alpha V2 as the destination the result would be amazing...
|
|
|
Audio Aficionado Sponsors | |