G-01 & 10MHz Output Cable Impedance

[SCAudiophile]

Originally Posted by adol290

SCAudiophile,


Thanks for all the great information on your clock.

I have been thinking of getting a clock for my K-03x for a while now. The esoteric option is a bit out of my range, so after reading your posts here and a few other places, I am considering the Cybershaft.

Do you prefer the OCXO clock, over the RB. Would you still suggest getting a clock that has both?

Is the prototype OCXO from the same manufacture?, is it a single or dual clock?

Best to do a bit more research before committing to single output 10 Mhz clock but if it's for your needs, I would highly recommend these products.

Have owned the Esoteric G-0s and G-03x and being previously focused on Rubidium must be better as it is 'more precise' I bought the RBOCXO-01 dual master clock from Cybershaft; 2 clock outputs, 1 each for a Rubidium side and 1 for the OCXO side. I used the Rb side exclusively for a few months then took several recommendations to try the ultra-low phase noise side with OCXO circuitry. Frankly, I have not been back to Rb in this clock since using the OCXO side exclusively. The prototype clock I am testing is a single output OCXO-only clock.

Please be aware the Cybershaft clocks only do 50-ohm 10 Mhz output so please make sure you are happy and able to support a 10 Mhz 50-ohm signal both in terms of your unit and the cable you utilize.

Questions,...write me anytime here or via PM. Happy also to jump on phone and discuss to the best of my experience how to help.