#1
|
|||
|
|||
Bi-Wiring for MX-Rs
How does one utilize 2 separate runs on each channel with the MX-Rs? Do both runs have to soldered to one connector or can 2 connectors fit? I can't see being able to fit 2 connectors under the screw block.
|
#2
|
||||
|
||||
dminches.......There are a number of speaker cable manufacturers who will assemble the cables with a single pair of spades on the amplifier end and dual sets of spades on the speaker end. This is an example of a Wireworld speaker cable that is set up to bi-wire speakers from a single pair of amplifier terminals.
What exactly is it you think you will gain bi-wiring your speakers?
__________________
Dan STUDIO - McIntosh C1000C/P, MC2301 (2), MR88, Aurender N10, Esoteric K-01X, Shunyata Sigma spdif digital cable, Sonos Connect, PurePower 2000, Stillpoints, Furutech Flux 50, Michell Gyro SE, Michell HR Power Supply, SME 309, Ortofon Cadenza Black, Wireworld, Sonus faber Amati Anniversario LIVING ROOM - McIntosh C2300, MC75 (2), MR85, Magnum Dynalab 205, Simaudio MOON Neo 260D-T, Schiit Audio Yggdrasil, Aurender N100H, Shunyata Sigma USB cable, Micro Seiki DD40, Ortofon Cadenza Blue, Nakamichi BX-300, Sony 60ES DAT, PS Audio P10, Furutech Flux 50, Sonos Connect, Stillpoints, Wireworld, Kimber, PMC EB1i, JL Audio f113 VINTAGE - McIntosh MA230, Tandberg 3011A tuner, Olive 04HD, Sony DTC-59ES DAT, McIntosh 4300V, JBL 4312A Last edited by jdandy; 04-21-2015 at 05:26 PM. |
#3
|
|||
|
|||
My Vandersteen Model 7s need to be bi-wired. They can be internal bi-wire. Some have said that 2 separate runs is better.
|
#4
|
|||
|
|||
I am curious if anyone has 2 sets of spades connected to each + / - terminals. Is there room and is the connection tight?
|
#5
|
|||
|
|||
I have exactly this setup with MX-R and both spades fit quite easily.
|
#6
|
|||
|
|||
Thanks. I called Ayre and that's what they said.
|
#7
|
|||
|
|||
Do you guys use the Cardas type barrier strip spades on the Vandy 7's? I'm currently using non-biwire bare end 10ga pure silver wire but am consider biwiring with parallel copper runs from the MX-R's. Just want to get the right connectors ... I was thinking non-plated Cardas barrier spades on the speaker side and 1/4" non-plated copper spades on the MX-R end.
Andy |
#8
|
|||
|
|||
I have a shotgun biwire set of Audioquest type 6 from VX-R to 7's both with AQ spades soldered in. richard strongly advocates using an external bi-wire. i suggest you ring him up. he answers the phone.
Btw, speaker wires are the weak link in my system. The Cardas blocks on the amp are very accomodating. |
|
|
Audio Aficionado Sponsors | |