|
#1
|
|||
|
|||
Sc7s2
Running unbalanced, can a splitter be used to run two subs from the pre-out?
|
#2
|
||||
|
||||
Try it and see if it sounds OK. There are two sets of RCA outputs which are paralelled, not individually buffered. I doubt it will harm anything, if it sounds bad, the load is too much.
__________________
System: ML:5206,5302 Serafino's Nordost Lumin U1 RM15 |
#3
|
|||
|
|||
Another question: Can this pre use one balanced pre out and one RCA out to different amps at the same time. Someone has advised that this could be done and it works but the manual seems the opposite.
|
#4
|
||||
|
||||
I've pondered this question many times. I think it will work fine. My best guess is that the manual implies you can't run balanced and RCA to the same amp.
__________________
System: ML:5206,5302 Serafino's Nordost Lumin U1 RM15 |
#5
|
|||
|
|||
Quote:
|
#6
|
||||
|
||||
I do this also - essentially run stereo subs.
|
#7
|
|||
|
|||
guess i'm too new to create a new thread. Anyway, i'm using MA9S2/SC7S2 combo with the new Marantz CD player..think its the SA11S3. Am wanting to try some balanced interconnects but I can see the pin arrangement of all the marantz hardware is different than most manufacturers. Is there a problem using some aftermarket balanced interconnects such as Mogami, Morrow or Signal? I would think as long as the components being connected are all Marantz there this would be Ok. true?
|
#8
|
|||
|
|||
Good question. I would like to know the answer to this as well, although I do not think I can use a sub at that point.
|
#9
|
||||
|
||||
Quote:
|
#10
|
||||
|
||||
Quote:
For some reason the USA and Europe have different standards, pin 1 is ground for both but pins 2 & 3 are reversed.
__________________
System: ML:5206,5302 Serafino's Nordost Lumin U1 RM15 |
|
|
Audio Aficionado Sponsors | |