|
Magico Extreme Fidelity |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Quote:
|
#12
|
|||
|
|||
Magico even go as far as recommending using two set of single wire cables, rather than a single set of biwire cables.
Problem is I use Transparent cable, they do not recommend double run of their cables from single amplifier. And they do not make biwire cable at top level of their range. They recommend me 1045$ OPUS jumpers, which made from raw cables that used in OPUS. With 8" each. That means the OPUS Carbon network boxes costs 27,000$ and 6000$ for cables in 8-feet pair. With Q7 coming I will not afford any new cables for the moment. Toga Last edited by TOGA; 04-12-2013 at 10:33 PM. |
#13
|
|||
|
|||
Why not order Q7 in single wire config ? I have seen someone mentioning that possibility.
|
#14
|
|||
|
|||
Because they are the last pair available. New order will be much much more $$$$$.
And bi wire version has higher potential in the future. I could try bi amps in the future too. But main reason is that they are last pair before new price. Toga |
#15
|
|||
|
|||
Quote:
Yes, the Transparent jumpers are probably the best way to go at this point. I would consider banana to banana configuration on the jumpers and leave the OPUS spade terminations. This should yield very little loss. You might try experimentation to connect the OPUS to either bass or high frequency posts to find your preference. |
#16
|
|||
|
|||
My speaker cables are not OPUS, but the one below that. They are Reference MM terminated with spades.
But Transparent recommended me OPUS Jumpers with locking bananas. I wanted to send them Furutech CF202 To terminate with jumpers, but their cable diameters are too large for Furutech s. Normally I connect jumper in crossing way. Red to red of HF and black to black of LF. This way jumpers will have Effect on both HF and LF terminals, Toga |
|
|
Audio Aficionado Sponsors | |