|
Audio Research State of the Art Audio Reproduction |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
May I run Reg40 sans tube dampers ?
Hi,
I noticed all 6H30 dampers torn apart after 8,000 hours of Service. It will cost me 9$ each for a new one. Next time I replace 6H30, may I just run it naked ? Or do you know how much is it from US ARC dealer? Thanks Toga |
#2
|
|||
|
|||
You can try these ... http://herbiesaudiolab.net/tube.htm
There's a thread on Agon with many happy ARC owners. |
#3
|
|||
|
|||
or .........just by some hi-temp silicone o-rings. your tubes will never know the difference and your wallet will thank you !
|
#4
|
|||
|
|||
tubes will never know the difference but ear might.
|
#5
|
|||
|
|||
My Ayon CD35 runs on 6H30 too, without any dampers.
I think I will try bare 6H30 on Ref40 first, if needed then just pay $90 For ten orignal dampers. The Herbie's are even more expensive, but which I don't have A clue how it will sound. Toga |
#6
|
|||
|
|||
two words, here's the initials ...... 'BS'
|
#7
|
||||
|
||||
Quote:
I am not sure what you mean by torn apart. I see no damage on any of the ones I have. Sure you can just run the 6H30 tubes without any type of dampers. I replaced all my ARC tube dampers with Herbie's Ultrasonic tube dampers. I have them on all my 6H30 tubes. I like them better than the ARC tube dampers. The Herbie's are very well made and I think they make a difference. ARC must have thought that dampers were important to include them. They have always used them on the 6H30 tubes and have changed the design a few times. I remember 3 or 4 different types. I think they used them even before that. I vaguely remember dampers on 6922 tubes in the 90's. |
#8
|
|||
|
|||
Quote:
At 4300 hours I replace all 6H30s, but when I tried removing them some of them torn apart as two separate O-rings. Yes they broke because of me pulling them, but actually I had a feeling that they loss the rubber flexibility already. Let's say this instead, at 8000 HRS all the dampers became hard and I expected a loss of dampening property. I need ten of them and Herbie suggest heat resistant model for 6H30 which cost 40$ each . that will make 400$ total, same as ten 6H30 itself. And I am not sure how long I will keep this Ref40 so I just want to find the best price for original ARC dampers, which I am sure way cheaper than 9$ in my country. So if you know where I can buy one from US. thanks. Toga |
#9
|
|||
|
|||
|
#10
|
||||
|
||||
It has been quite a while since I replaced the dampers on my 6H30 tubes. But as I remember the ARC dampers were two separate black O rings on each tube. I also remember a tip saying to make sure the two rings were touching and as high up on the tubes as possible. But different pieces came with different types of dampers over the years.
|
|
|
Audio Aficionado Sponsors | |