Quote:
Originally Posted by BearCityUSA
There is a diagram put together by the OP for LP-2, Lp-3a and LP-27A (all the same inputs/outputs) not sure if I have seen one for the Lp-1. You can open it up and trace the wires from the selector switch. While you have it open post a pict of the inside here. Wiring porn always goes over well with these readers.
BTW those open corners on the chassis are DH originals. Back when he was building his own chassis and painting them out back in his open air spray both. Ill bet that pre is past its burn in cycle and sounds smooth as silk.
|
I did that basic "manual" for the LP-2 a few years ago. Dennis changes his designs enough that it is not universal. In general, it seems he puts the output jacks to the left of the input jacks when looking at the rear of the preamp.
Here is a link to it, FWIW. (If you are reading this post well after I posted it, the link may be dead):
https://1drv.ms/b/s!Akltgq2oZfdfil9s-YwAe2VEBo0c