[jdandy]

Originally Posted by rjryan

This looks like a really good option, but can you comment on the loading? I'm not sure my C2600 would have the infinite adjustability needed to make it really sing.

rjryan.......From the information I have been able to glean, the Grado Statement V2 phono cartridge will require a 47K loading, the same loading as a moving magnet cartridge. The drawback with your C2600 is moving coil resistance loading only provides for a maximum 1000 ohms loading. This means the Grado Statement V2 will require being used with your moving magnet phono stage to achieve the proper 47K loading. Another drawback is the Grado Statement V2 1.0mV output will not provide sufficient output voltage to maximize signal to noise or dynamic range with the moving magnet phono stage without a step-up-transformer. The C2600 requires 4.5mV for rated output. A cartridge with a rated output of 2.5mV would be satisfactory but one with a 1.0mV output is low.

I am not saying the Grado Statement V2 cartridge won't work connected directly to the C2600 moving magnet phono input but it will not yield its best performance unless the output is boosted. If you are using or plan to use an outboard phono stage that has a switchable step-up transformer built in then you will be set, otherwise you will probably need to consider the addition of a SUT to the mix. This will also necessitate an additional pair of phono interconnects as well.

By all accounts the Grado Statement V2 cartridge is a serious performer that rivals many competitors at much higher price points. The sound produced by this cartridge is reported to be spectacular. Just be aware that it will require some additional investment to achieve its premium level of performance with your C2600 preamp.