View Single Post
  #2  
Old 07-19-2009, 07:41 PM
jdandy's Avatar
jdandy jdandy is offline
Merry Christmas to all



 
Join Date: Apr 2009
Location: North Central Florida
Posts: 53,224
Default

wpines.......I don't believe you will need any isolation transformers, unless you have your heart set on a couple MPC1500's.

My advice is to run a minimum of two dedicated circuits to your rack location, and possibly a third one to where a powered sub may sit. The circuits should be 20 amps each, minimum 12 gauge wire, with seperate hot, neutral and ground for each circuit. If the circuit runs exceed 50 feet from the panel I would go to 10 gauge wire to keep voltage drop to a minimum. Keep the dedicated circuits, each dedicated circuit breaker, on the same phase in your panel. Use 20 amp PS Audio Soloist Premier outlets. Install surge protection on your house panel if it has not already been done.
__________________
Dan



STUDIO - McIntosh C1000C/P, MC2301 (2), MR88, Aurender N10, Esoteric K-01X, Shunyata Sigma spdif digital cable, Sonos Connect, PurePower 2000, Stillpoints, Furutech Flux 50, Michell Gyro SE, Michell HR Power Supply, SME 309, Ortofon Cadenza Black, Wireworld, Sonus faber Amati Anniversario
LIVING ROOM - McIntosh C2300, MC75 (2), MR85, Magnum Dynalab 205, Simaudio MOON Neo 260D-T, Schiit Audio Yggdrasil, Aurender N100H, Shunyata Sigma USB cable, Micro Seiki DD40, Ortofon Cadenza Blue, Nakamichi BX-300, Sony 60ES DAT, PS Audio P10, Furutech Flux 50, Sonos Connect, Stillpoints, Wireworld, Kimber, PMC EB1i, JL Audio f113
VINTAGE - McIntosh MA230, Tandberg 3011A tuner, Olive 04HD, Sony DTC-59ES DAT, McIntosh 4300V, JBL 4312A

Last edited by jdandy; 07-19-2009 at 07:44 PM.
Reply With Quote