View Single Post
  #16  
Old 10-15-2017, 07:03 PM
ariess ariess is offline
Member
 
Join Date: Jul 2012
Location: Baltimore
Posts: 763
Default

Quote:
Originally Posted by dtaudio View Post
Thanks for the responses regarding posting photos. It doesn't appear that I will be able to do so at this time as I don't seem to have the right permissions.
So here is my shot at describing the room treatments. The process started by me sending Chris Huston photos of the room as well as many detailed measurements. He developed a plan that he felt would address any sonic issues as well as blend with the existing architectural features of the room. After my approval, he sent me working drawings for all the treatments he recommended as well as detailed elevations showing exactly where they should be installed.
I have access to a small millwork shop and I am a reasonably skilled amateur carpenter so I was able to construct almost all of the treatments and install them myself.
There are two main areas Chris focussed on - the sidewalks and the ceiling. The room doubles as a home theatre so a large flat panel TV occupies a fair bit of the front wall making placing treatments there difficult. The rear wall has a floor to ceiling built in cabinet with many open shelves for media storage as well as being the location of the entry door to the room.
The main feature of the sidewalls are large panels which I will call slat diffusers (this may not be the correct technical name). Each one measures 6' 3" long by 6' 4" high and consists of a repeating pattern of vertical "slats" all 1 1/2" wide but varying in depth from 1 1/2" to 5 1/2". They are spaced 1" apart. There is an absorbing section on top of the slat panel that extends to the ceiling.
There are also 3 24"x48" absorbing panels (Corning 703/705) on each side wall; one toward the front of the room and two toward the back of the room.
The ceiling treatment is twofold. There are 8 24"x24" Auralex Wavelens diffusion panels located in about the middle of the ceiling as measured front to back. They are installed in a staggered pattern. The rear portion of the ceiling contains 5 24" x 24" absorbing panels made using Corning 705 and again in a staggered pattern.
All this is a bit difficult to describe but I hope this gives you the idea. As I mentioned in an earlier post, the outcome, to my ears, has been excellent.
If you email me the pictures I can post them.

Last edited by Masterlu; 10-15-2017 at 08:05 PM. Reason: Posting your email address is against Forum Rules.
Reply With Quote