[jdandy]

The two hangers I fabricated are shown below. They are made from high tensile strength steel fish tape that electricians use to pull wire through conduit. It is very difficult to bend and once shaped remains that way. The bottom of the hanger is bent to hook into the holes I drilled in the back of the panel. The top of the hanger is formed to the shape of the top of the widescreen television. Both hangers are identical. I used shrink wrap tubing over the part of the hanger that contacts the television frame to keep the steel from scratching the TV frame. Once the hanger was hooked into the hole and aligned upright I shot a staple around the hanger to hold it in place. That way I can easily lift the panel on and off of the television without having to try and hold the hangers in place. It works like a charm.