I've decided to remove the Bryston 10B entirely, and use the Velodyne SMS-1 bass manager to set the low-pass crossover to the subs. I've been reluctant to use the SMS-1 for this because it requires a video monitor, and there are so many parameters that can be set, but a careful reading of the manual suggests I need go no deeper than adjusting the crossover then letting the SMS-1 run in auto mode to do the rest of the setup from its acoustic measurements. Given the LS50s are running full range, I want to creep up to the steep rolloff point to reduce overlap, so I'll start at 50 Hz and leave the slope at the default 24 dB/octave of the SMS-1.
db
|