Quote:
Originally Posted by John Jordan
OK, so I have some questions for the sake of clarification:
1. Stephen-
I see you have two phono plugs. Is one connected to the pre-amp and the other to the DAC or phono stage? Or is one phono plug on an unused pre-amp jack all that is needed?
2. tdelahanty-
Where exactly do you place the volt meter leads on the component to check for "dangerous voltages?"
Thanks
|
Locate a screw or panel on each component that is attached to the chassis. Place your AC voltmeter there (make sure they are not painted) and set the meter to 120v ac.
__________________
System: ML:5206,5302 Serafino's Nordost Lumin U1 RM15
Last edited by tdelahanty; 01-26-2020 at 07:36 PM.
|