Thread: IRS Beta
View Single Post
  #10  
Old 01-01-2021, 11:02 AM
CR500 CR500 is offline
Guest
 
Join Date: Dec 2020
Posts: 3
Default

Another Beta owner who would like to know!

Was playing with my setup and spectrum analyzer last week. Trying to cure huge dead spot in the spectrum around 70 Hz (bad room acoustics). While playing, I discovered the EMIT and EMIM controls weren't working. I'm going to get some replacements rather than cleaning. Could only find wire wound types (5 ohm 5 watt).

Anyone know where to get one of the standoffs for IRS Beta woofer grills? They look the same as those used on the other cabinet, just with the addition of a bushing.

Were they used on any of the other speakers?

How do you remove them from the grill (do they unscrew or pull off)? If I can get one out, I'll try to scan and 3d print them, just want to make sure I'm not going to break anything when attempting to remove (they're all very tight).

... and the foam inside the passive crossover box has deteriorated on mine. Probably the same for everyone as well. Time to pull it out and replace before it becomes a sticky mess!

Thanks!

Rob

Last edited by CR500; 01-01-2021 at 04:06 PM.
Reply With Quote