Quote:
Originally Posted by Josquin des Prez
I have the VTALifter2 on my Clearaudio Ovation. When I had the Clarify arm, which is a magnetic bearing arm, changing VTA caused a change in VTF. Now I have the Magnify arm, which is a hybrid bearing (magnetic in one plane only). Changing VTA changes the VTF very little. In fact none at all over the range I adjust VTA. So I think your point about changes in VTA changing VTF depends on the tonearm. But I do agree it is good to check.
As for changes in VTA changing stylus overhang, I setup my table for specific VTA (slightly tail down). I change the VTA to accommodate different record thicknesses (i.e from 110g to 200g) so that I keep the same relative VTA. My adjustments to VTA change it relative to the platter, but not so much to the stylus resting on the actual record, so I think the overhang changes little or not at all.
|
VTA always changes when you change VTF ............