Thanks, Tom. Yes, these are circuit board chassis pins apparently. Turns out I was able to figure something out with the help of a car audio guy and a computer guy. Bought a single auto fuse holder (with cable in and out) and a fuse for same (you know the flat type with the wavy element in it). The computer guy will solder the pins of the breaker to the fuse, then plug it in and test for continuity of course. Should be fine. Next will be to see if it cuts out too often, though I doubt it will as it is not often it gets those high sound levels. Can always go up a step if needed.
Much appreciated your time on this in any event, Tom. Thanks!
|