[Randy Myers]

I totally assume that in many cases the designs have been advanced with further evolution in the Pass lineup. And it is not a Goldmund/Job situation. It is in fact Nelson Pass's personal playground. Where he can experiment and explore new designs that he would not be able to in the "commercial line".

As he states:
"Dick Olsher famously remarked that “The first watt is the most important watt.” This sentiment has also been expressed by others as “Who cares what an amplifier sounds like at 500 watts if it sounds like crap at one watt?” With this in mind, I created First Watt in 1998 as a "kitchen-table" effort, exploring unusual low power amplifiers with an emphasis on sound quality.

Small amplifiers have a number of advantages over “big iron” in that very high quality can be achieved with simple Class A circuits using little or no feedback.

There is no such thing as a perfect amplifier. All audiophiles and their associated equipment have specific needs, but in each case there is such a thing as a best amplifier - the one that makes you happy.

First Watt exists because I wanted to explore a variety of amplifier designs in what I think of as neglected areas - amplifiers that might not fit into the mainstream and are probably not appropriate to my more commercial enterprise, Pass Labs.

With oddball characteristics and output power ratings of 25 watts or less, First Watt is not for most people. If you have efficient loudspeakers, listen at reasonable levels and are obsessed about subjective performance, then you probably have come to the right place.

If you want reliable audio product, then you really have come to the right place. For twelve years First Watt has had a near-zero failure rate.

First Watt amplifiers are routinely compared with tube amplifiers, although I make a point that they are not designed to mimic tubes as such. These amplifiers share some of the characteristics of the better tube products in that they have simple circuits with minimal or no feedback and emphasize performance of individual gain devices. In some ways they are better than tubes, in other ways perhaps not."

And his statement as to why he turned over the actually building of these amps to Pass Labs:
"This has always been about making amplifiers.

Dick Olsher famously remarked that “The first watt is the most important watt.” With this in mind, I created First Watt in 1998 as a "kitchen-table" effort, exploring unusual low power amplifiers with an emphasis on sound quality. I wanted to design a variety of amplifier designs in what I think of as neglected areas - amplifiers that might not fit into the mainstream and are probably not appropriate to my more mainstream business, Pass Labs.

Fourteen years later I have largely accomplished that goal, but along the way it seems that I have created a commercial enterprise that has outgrown my ability to handle alone. I tried addressing that by hiring my nephew and son to help, but they wandered off to their own careers (as offspring will do), leaving me with all the work.

Don't get me wrong, I like work - It's good for you. Building product is fun and keeps me grounded, but production demands are not leaving me with enough time to pursue the vast array of yet-to-be-designed amplifiers. So I am doing the logical thing, which is to hand the business end of First Watt over to Pass Labs, bringing my three business partners to the table as well. My relationships with these people stretch back to 1972 with ESS, through the Threshold years and for the 25 years of Pass Labs, and I'm certain they can do the job flawlessly.

Starting in April, Pass Labs will be building First Watt amplifiers and will also take responsibility for marketing and distribution. Support and service policies will remain the same.

I will continue at what I do best, the fun part."

And about heat:
"Q: Why do they run hot?

A: They are Class A amplifiers. They are very linear, but they run hot. Can I make them sound good without Class A? No. Because they run hot, it is important that they get good ventilation. Do not place them in a closed cabinet or on top of another hot amplifier."

Other info:
"Q: Do you really build them yourself?

A: Yes, until this last year, when my son Colin and nephew Sean began helping with assembly.

Q: Why do they all look the same?

A: Years ago I bought a lot of chassis parts in order to get volume pricing, and they are not used up yet. You can look forward to seeing this chassis for quite a while.

Q: What is the warranty?

A: 3 years parts and labor. We have not experienced a warranty case yet, but I imagine the service is good...

Q: Is there really a 0 percent failure rate on these amps?

A: Pretty much. One customer reported a case of bad solder connection, but the amplifier was apparently still running when it was discovered. He soldered it himself. Other than that, just the odd case of shipping damage."

He has at times expressed that designs he comes up with in First Watt many times gets passed on to Pass Labs.

Nelson also told me with life and such his son and nephew moved on to other things, so he could not personally keep up with the hand building. This is why he moved the assembly work to Pass Labs. Mine was built just before the move to Pass Labs, so I am fairly certain it was hand built by Nelson.

Any way a lot of good info.

So you totally understand, I am not saying that First Watt is exactly the same as Pass Labs. And certainly the Goldmund/Job analogy does not apply because these are designed and until recently hand built by the man himself. They are very fine amplifiers that sound as pure and accurate as any amplifiers in their price level if you fit the bill of someone looking for purity and not huge amounts of power.

I will put forth one proposition however, by an amp being sold and marketed within the Pass Labs moniker does impose certain restrictions. As Nelson himself stated, "First Watt exists because I wanted to explore a variety of amplifier designs in what I think of as neglected areas - amplifiers that might not fit into the mainstream and are probably not appropriate to my more commercial enterprise, Pass Labs." So with First Watt he can experiment and try things. When he comes up with a worthy design and tests to be something special, he creates a new model. It could be argued that First Watt may in fact be the better of the two. I am not saying it is, but do not assume just because it has the Pass Labs label makes it the superior of the two. After all Nelson backs both amplifiers the same and the First Watt actually has the better track record. He designs both but states, very clearly, that one is more "personal" to him. Also, one other consideration... if you have an issue with Pass Labs you call your dealer or Pass Labs. If you have an issue with First Watt, even now that Pass Labs is assembling them, you call Nelson. He personally stands behind them, and so far has had ZERO warranty claims.