Quote:
Originally Posted by imprezap2
changing the rake is not lifting the speakers, it's the angle of the front baffle to the floor
|
This is correct. To build and hopefully not too complicated but if you think of the front baffle or face of your speaker forming a 90 degree angle with the floor if perfectly level. Then If you were to raise only the front of the speakers up (say you put two quarters underneath each front spike) you would be changing the rake angle.
Follow the your speaker mfg recommendations on this. At the very least get your self a laser and make sure both speakers have the same rake. You could also just make sure the tops of both speakers is perfectly level.
__________________
Main Equipment: Kharma Elegance dB11-S, JL Audio F113v2 X 2, Block Audio Line & Mono SE Amplification, Bricasti M21 DAC, Antipodes Kala K-50 Server, Clearaudio Performance SE. Satisfy tonearm & Maestro Wood MM cartridge.
Power: Shunyata Everest 8000, Sigma XC v2, Sigma NR v2, Block Audio PCs, Defender, ADDPowr Wizard
Grounding: Shunyata Altaira CGS - 4 X Alpha CGS cables,
Network : Supra Cat 8+, Twin (Nenon) Modified Buffalo GS2016 Switches, Keces P3 LPSU,
Cables: Wireworld Platinum 8 USB, Wireworld Platinum Eclipse 8 Speaker cables, 6M & 1M Tubulus Concentus ICs,
Other:Two PSI Audio AVAA C20, Multiple GIK products, Stillpoint Apertures, Stillpoint Minis and Ultra SS, Three 20 Amp lines, Furutech GTX - Gold outlets, Adona Rack
|