MEMO: To All Bryston Customers
SUBJECT: Bryston BAX-1 Digital Crossover GUI
May, 2017
Model T BAX-1 Active Crossover GUI
Hi Folks,
Please see below the GUI that is available with the new Bryston BAX-1 Digital Electronic Crossover.
Most room problems occur below 120Hz due to standing wave issues.
The BAX-1 GUI allows you to modify the factory preset frequencies from 30Hz to 120Hz in 1Hz steps. You can also enter any frequency you wish and make the same adjustments.
You can ‘increase’ the gain a maximum of 3dB or ‘reduce’ the gain by 6dB in 0.1 increments at the frequency chosen.
You can also adjust the ‘Q Factor’ in 0.1 steps. The factory setting for Q is ‘3’
The Red Line in the graph at the bottom indicates the changes you are making.
After making the appropriate adjustment just hit SAVE.
|