Hello Accuphase lovers!
A have a question for you: can a PS-1230 work with a pair of M-6200 + C-3850 + DP-750?
My room has 20mp and my speakers are Dynaudio Confidence C4.
I don't listen to music at very high volume.
I don't find owners manual in english for this product.
From what I understand from a japanese PS-1230 owners manual with google translate:
"Turn off the power switch of PS-1230 or the connected device.
Refer to the catalog and instruction manual of the connected load device, and the total power consumption of the load device should not exceed 1200 VA.
Select the device.
Refer to page 13 for a list of power values for the main products.
After connection, turn on the power, press 4 button, and the meter display should not exceed 1200 VA
Make sure that In addition, when a pre-main amplifier or power amplifier is connected, the sound is actually output from the speaker, The meter reading should not exceed 1200 VA.
When including loads such as power amplifiers, where power consumption varies greatly depending on volume It is recommended to use at about 800 VA when there is no signal. For large output There is a risk of exceeding 1200 VA.It is recommended to use at about 800 VA when there is no signal.For large output There is a risk of exceeding 1200 VA.
If the meter reading is 1200 VA or less, turn on / off the power switch of the unit with the connected device turned on.
can.
Since the rated capacity of PS-1230 is 1200VA, it is more than the total power consumption displayed in the catalog.
Please select a model. In particular, the pre-main amplifier and power amplifier have a large difference between W and VA.
Is necessary. For low-power models such as tuners, CD players, and preamplifiers, add power consumption (VA value).
Select the device.
● The power consumption of the pre-main amplifier and power amplifier varies depending on the size of the music output.
Refer to the display power according to the Elegance Safety Act.
The electrical power according to the Electrical Appliance and Material Safety Law is a measured value at the lowest rated impedance, so it is a fairly large value.
The However, when listening at a normal volume with a speaker with an impedance of about 8Ω, the power consumption is small.
This is the value between when there is no signal. For this reason, the meter reading is 1200VA at the maximum volume when the sound is actually emitted
If it is within, it can be used.
● In case of overload exceeding the rated capacity, the 4 meter display switch button LED will flash to warn you. Ignore this
If the power becomes even higher, a circuit protector (breaker) that doubles as a power switch shuts off the power.
The In such a case, reduce the number of connected devices to 1200VA or less and turn the power switch on again."
Thank you very much in advance!
|