So while I was experimenting with placement of my Calibres, I did notice that I like the added clarity on the top end while standing, as opposed to sitting, due to the slightly sloping front baffle. While on my couch, the front midbass speakers are roughly at ear-level which is great, but due to the limited vertical dispersion of the 1"x4" AMT tweeter, I did find that I'd rather have them angled down a little bit. I'd rather not lower the whole speaker itself since that would look rather weird, lol. But then, I'm not sure how to tackle the angle issue altogether. I know very basic woodworking, so I don't think I'd be able to create an angled bottom support. I can do metal fabrication and welding, but I'd rather check to see if I can buy a pre-made solution.
Anyone have a good link to perhaps angled isolation pads that would hold up to 50lb speakers?
|