Switching between “Pre“ and “Post“ is effected via software: Press and hold the “LINE“ pushbutton for about two seconds until the green LED starts flashing. The present status is displayed by the “XLR” LED (pre fader) or the “DIG” LED (post fader). The setting can be altered now by pressing the corresponding button. To complete the setting procedure, just press and hold the “LINE” button again until the green LED stops flashing.
LINE-OUTPUT LEVEL can be set by means of internal DIP switches located on the line-out circuit board. See page 33 for further details. Generally, the level at the unbalanced output will equal the input level in pre-fader mode, or with the level control set fully clockwise in post-fader mode. By means of the DIP switches however, relative attenuation/gain can be set to –12, -6, 0, +6 or +12 dB. Please note that output level at the balanced output is generally +6 dB higher than at the unbalanced output.
THE “MUTE“ FUNCTION serves to mute ALL outputs. On the V281, it can only be activated via remote control.
|