AudioAficionado.org

AudioAficionado.org (https://www.audioaficionado.org/index.php)
-   Audio Research (https://www.audioaficionado.org/forumdisplay.php?f=91)
-   -   ARC VSi75 (https://www.audioaficionado.org/showthread.php?t=18787)

Amado 01-25-2013 04:03 PM

ARC VSi75
 
I just received the ARC VSi75 Owners manual
if anybody wants to check it out just let me know and I will send a copy to your email

Nelson

cmalak 01-25-2013 04:21 PM

Nelson...I was not aware there was a VSi75? Is this an integrated based on the Ref 75 design?

joeinid 01-25-2013 04:24 PM

Wow!

That sounds very interesting......

SundayNiagara 01-25-2013 04:52 PM

I've been told it's a totally new package and not an upgrade from the VSi60. Can ya post the specs?

Amado 01-25-2013 05:01 PM

Specifications
Power Output: 75 watts per channel continuous from 20Hz to 20kHz. 1 kHz total harmonic distortion typically 1.5% at 75 watts, .05% at 1 watt.
Approximate actual power available at “clipping” 80 watts (1kHz). (Note that actual power output is dependent upon both line voltage and “condition” i.e.: if power line has high distortion, maximum power will be affected adversely, although from a listening standpoint this is not very critical.)
Power Bandwidth: (-3dB points) 12Hz to 70kHz.
Frequency Response: (-3dB points at 1 watt) 1.0Hz to 70 kHz.
Input Sensitivity: 0.55V RMS Single-ended for rated output. (32.5dB gain into 8 ohms.)
Input Impedance: 52.5K ohms Single-ended.
Inputs (5): 1, 2, 3, 4, 5 (Single Ended RCA connectors).
Maximum Input: 10V RMS (any input).
Output Polarity: Non-Inverting (any input).
Push Buttons: Volume up, Volume down (103 steps), Power, Input, Mute, Bias. All functions on IR remote control.
Output Taps: 8 ohms, 4 ohms.
Output Regulation: Approximately 2dB 8 ohm load to open circuit (Damping factor approximately 4).
Overall Negative Feedback: 4dB.
Slew Rate: 10 volts/microsecond.
Rise Time: 4 microseconds.
Hum & Noise: Less than 1.0 mV RMS -88dB below rated output (IHF weighted, Vol down).
Power Supplies: Electronically regulated Low and High voltage supplies for input stages. Automatic 40 sec. warm-up/brown- out mute.
Power Supply Energy Storage: Approximately 350 joules.
Power Requirements: 100-125VAC 60Hz (200-250VAC 50Hz) 400 watts at rated output, 600 watts maximum, 210 watts at
“idle’: 1.0 watt power off.
Tubes Required: 2-Matched pair KT120-Power Output; 2 -6H30 driver.
Dimensions: Width 14.5” (36.8 cm) Height 9.25” (23.5 cm)
Depth 16.25” (41.3 cm) Rear connectors extend .88” beyond chassis.
Weight: 36.4 lbs. (16.5 kg) Net; 49.3 lbs. (22.4 kg) Shipping.
This unit is RoHS compliant
HIGH DEFINITION®
Specifications subject to change without notice. ©2013 Audio Research Corporation.


Amado 01-25-2013 05:02 PM

1 Attachment(s)
http://www.audioaficionado.org/attac...1&d=1359147729

Amado 01-25-2013 05:04 PM

Quote:

Originally Posted by cmalak (Post 432869)
nelson...i was not aware there was a vsi75? Is this an integrated based on the ref 75 design?

you know me
always with the latest in arc

Amado 01-25-2013 05:06 PM

1 Attachment(s)
Look they are going with the Digital Front Display
very nice !!
http://www.audioaficionado.org/attac...1&d=1359147959

Amado 01-25-2013 05:07 PM

1 Attachment(s)
Tube meter
I like it !!!!
http://www.audioaficionado.org/attac...1&d=1359148061

mbovaird 01-25-2013 05:11 PM

Very nice!!! Thanks for sharing.


All times are GMT -4. The time now is 04:32 AM.

Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
©Copyright 2009-2023 AudioAficionado.org.Privately owned, All Rights Reserved.