PMC MB2i SE - Bi-amp or Single amp
I have a pair of PMC MB2 SE on order.
I am trying to decide whether to use a single Bryston 28b3 on each speaker. The 28b3 has dual binding posts, so one cable to the bass, and one cable to the Mid/tweeters. Or do a 7b3 on the bass and a 4B3 bridged on the midrange/tweeter. I already have the 7b3's and 4b3 to do the bi-amp. Has anyone tried bi-amping vs single. |
single 28's with biwire.
|
Single Amp to Single Cable to binding posts on Speakers here.
|
Why don't you try the 7b3s first and hear if that's enough? Adding the 4b3 you will need an active crossover as well.
|
Well i am still waiting on the speakers, but good comments here.
I will try the 7b3's first. And just for fun, i am going to run a splitter on my interconnects(no crossover) and try the 7b3's on the woofers and the 4b3's(in bridged mode) on the mids, with a jumper to the tweeters. Too bad i don't have a crossover to try. BTW has anyone heard of any Board or electronic issues with the MB2 SE. Just curious because i had a pair of Ib2i actives and had a number of issues with the boards. I also have a friend who has the Fact 12's and he had to send his speakers back for service due to electronic issues. Just don't want that type of surprise again. |
What taps off your amps will you be using when bi-amping?
|
Quote:
The MB2's are 4 ohm. There is no selection on the bryston amps for 8 or 4 ohm. |
I think you will find the MB2se are 8 ohm.
|
Folkman... Welcome to AA! :wave:
|
Quote:
|
All times are GMT -4. The time now is 02:43 AM. |
Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
©Copyright 2009-2023 AudioAficionado.org.Privately owned, All Rights Reserved.