Tax... Welcome to AA! :wave:
|
Thank you!
Quote:
|
Really no such thing as a Directional fuse as the current flows thru the fuse and if too much current flows thru the fuse the metal will "melt" or burn thtu and then current to the device will be stopped. There is no +/- side to it. If it has a +/- on the fuse something is not right. Open your owners manual and buy the Mfg fuse for the unit vs some aftermarket fuse and call the tech dept and ask the experts for the unit.
|
Agreed it is a strange concept, but the fuse has a current arrow. The question was about current direction.
|
I have an LP2 Deluxe that I've had for 8-10 years. Unfortunately, it started going bad. It would constantly cycle through the power on sequence and never stay on. I sent it back to Lamm and they found a burned power resistor, which they replaced and charged plenty for it. It then was fine for a couple of months and then started doing it again. When I contacted them, they said it was fine while they had it. I was concerned when they repaired it because they couldn't say why the resistor blew other than it didn't have enought circulation around it. When I got it back, I had it on top of a cabinet with all the air it needed. I no longer have it in the system and replaced it with an ARC Ref Phono 2SE, but I feed fleeced.
|
I'm having the same problem now, any thoughts? Did you sort it out? I'll have them replace all the power resistors even is they measure ok. Sending it in soon. Trying the little loco while it gets fixed. Have beautiful new 417a's to use when fixed.
|
Caps and tubes often take out a resistor. That's where I would look.
|
..lamm
..is as good as it gets...congrats
|
All times are GMT -4. The time now is 07:39 AM. |
Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
©Copyright 2009-2023 AudioAficionado.org.Privately owned, All Rights Reserved.