5 3/8" x 17 3/8"

See it at www.add-powr.com

I am trying to understand the different products and their use-cases. Can the Sorcer and Wizard be used together?

Sorcer near electrical panel and Wizard near components such as PRE/DAC etc.?

I use both.

My system is plugged into a single circuit with six "separate" receptacles along the way.

The Sorcer x4 is plugged into the fourth receptacle (with an eleven foot power cord) from the panel along with one mono amplifier and the Wizard is plugged into the fifth along with Nordost Qbase8; my other mono amplifier is plugged into the sixth along with a power strip for TV, etc. including PS Audio Noise Harvesters and ADD-POWR ElectraClear.

Along the way in the first through third receptacles are various PS Audio, High Fidelity and ADD-Power plugin devices.

My 200 amp panel is located on the back wall of my listening area behind a closet, so I may eventually put it in the closet and route the power cable through the wall to the first receptacle, which along with the second receptacle is located in a Murphy bed "closet" re-constituted as an office between two closets where the first two receptacles reside opposite the "normal closet" walls (only three through six are accessible from the room itself); or, I might just put it on that "office" desk as it may be close enough to the panel, however, it is a sizable box.

The sound is so pleasing, for now I have hesitated to move the Sorcer.

I installed ElectraClear eau2’s into the open outlets of each of my dedicated 20 AMP lines my amplifiers are on. The impact was immediate. Listening to the Gene Harris Quartet’s “Listen Here” album streaming from Qobuz, I heard a stronger attack from each instrument which translated to more separation between instruments and depth in the sound stage.

A solid upgrade to my system.

Crazy how good these things work.

https://www.audioaficionado.org/atta...6&d=1602948138

I added two to the open outlets in my main floor system with the TV and I am amazed how the picture on the TV has sharpened up. I still am amazed

Yes, eau2 will affect video image as well. The effect of resonance is cumulative. The more on the AC line, the greater the effect.
This is because the harmonic resonance is interacting with video signals in the MHz. range.

Video image color saturation increases, depth of field perspective improves, greater contrast, greater image detail, very dimensional, and darker video blacks.

Bill

Not to beat this topic to death, but would a Wizard or the ElectraClear eau2’s possibly help with suspected DC Offset present in a nearby circuit in the house (detected through an audible buzz in both amp transformers as per the amp manufacturers service tech). The recommended Emotiva CMX 2 reduced but has not eliminated the noise.....interesting products for sure....

I had a similar issue.
I ended up having to run a separate panel piggybacking off my main outside panel, the new breakers were "in phase" which were 3 separate 20 amp dedicated lines in 10 GA, lines one & two for each amp and third to Denali and components. Off these 3 outlets (ps Audio outlets that I scrounged from their old power strips) and ran a ground rod off EACH outlet and a pigtail ground wire off each outlet (drilled a hole in the outlet box and ran the ground wire out) thereby grounding each amp and grounding the Denali directly to it along with the Altaria. The new sub panel also has a direct ground rod.
Quietness and peace.

Sorry, but no.