Sc7s2
Running unbalanced, can a splitter be used to run two subs from the pre-out?
|
Quote:
|
Another question: Can this pre use one balanced pre out and one RCA out to different amps at the same time. Someone has advised that this could be done and it works but the manual seems the opposite.
|
Quote:
|
Quote:
|
guess i'm too new to create a new thread. Anyway, i'm using MA9S2/SC7S2 combo with the new Marantz CD player..think its the SA11S3. Am wanting to try some balanced interconnects but I can see the pin arrangement of all the marantz hardware is different than most manufacturers. Is there a problem using some aftermarket balanced interconnects such as Mogami, Morrow or Signal? I would think as long as the components being connected are all Marantz there this would be Ok. true?
|
Good question. I would like to know the answer to this as well, although I do not think I can use a sub at that point.:scratch2:
|
Quote:
|
Quote:
For some reason the USA and Europe have different standards, pin 1 is ground for both but pins 2 & 3 are reversed. |
Quote:
|
I'm using my Marantz SC7s2 preamp connected to my Jeff Rowland amp through the XLR connections. I want to connect a Dynaudio 500 sub that has only one input.The preamp has 2 unbalanced outputs. I'm wondering if I can go from 1 pair of the outputs to the single input on the sub, using a y-cable. Will this cause any problems that anyone is aware of ?
Thanks Joel |
All times are GMT -4. The time now is 07:48 AM. |
Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
©Copyright 2009-2023 AudioAficionado.org.Privately owned, All Rights Reserved.